Build Log: Project Winter Equinox Part 2

X570 Aqua Arrived. 549/999

[​IMG]

[​IMG]
 
Took a fairly decent shot of the ram installed with my camera. Needed to make sure of the height before I cut the glass tubing tomorrow.  
 
[​IMG]
 

Tested it with the Dr Drop but yea. took that one apart for now to clean it. Still have to bend it for the temporary bridge on the distro plate.

At the moment I am trying to figure out a bit of a puzzle that is the pumps in and out. Lowered the radiator and I think everything will fit with the pump on its side. It will also provide enough room for a run from the out of the front rad to the distro plate [​IMG]
[​IMG]

[​IMG]

 

I think ive found the level of clean im looking for on these tubes now ive left this one in a pint of water/rubbing alcohol for a day or so after I managed to get some of the wondergrip gloves burnt on it.

 

[​IMG]

 

[​IMG]

You would not believe how much of a pain this was to get right.

 

Did a mild leak test a tiny amount of water and the air pump.

Got a mild leak due to an adapter being a bit fussy.

[​IMG]

 

Copyright 2020 © Will Phoenix